I have the following setup and I am trying to finalize it with vSAN so I can start load testing the setup.
-Two identical servers running 6.7.0 build 10764712
--each contains
---1.64TB spinning disk
---2 x 500GB nvme SSD. I didn't realize I couldn't use two separate cache drives unless I have more than one spinning disk. Lesson learned, can't raid, oh well.
---80GB DDR4
---2 x E5-2687W v3
---Intel two port X540 adapter - one port setup on maint/vmguest network and one port on vSAN iSCSI network
---built in 1Gbit NIC setup on maint/vmguest network
-Witness appliance running 6.7.0 Update 1 (Build 10302608)
--set to small so it has 10GB ssd and 15GB spinner
--two ports, one on maint/vmguest and one on iSCSI
Hosts and witness can talk to each other on all subnets. DNS resolves the maint/vmguest network ip. Witness is running on an entirely different ESX server and is not a member of the cluster, only the datacenter under vCenter.
I am selecting the "Two host vSAN cluster" from the wizard. Selecting my spinning disks and one ssd from each server(It actually auto picks). I get to the very last step and I can not finish. It's all green but it just says "review settings before completion", but nothing is on the screen otherwise. "Next" is grayed out. Tried this in chrome and IE11, same thing. Edge, can't even get past step 2 as the next button is gone completely. Firefox, same thing, no next button on step 2.
Any ideas here?